Function characteristics and installation operation methods of central air conditioning LCD thermostat!

The central air conditioning LCD temperature controller (fan coil control panel) compares its measured temperature with the set temperature through electronic logic circuits, controls the fans, water valves, etc. at the end of the central air conditioning, and is used in hotels, office buildings, shopping malls, industries, medical facilities, especially villas and other civil buildings to keep the controlled environmental temperature constant within the set temperature range. This temperature controller is equipped with a remote control and can achieve remote control< Characteristics:
Working mode: cooling/heating
Indoor fan adjustable: high speed/medium speed/low speed/automatic
Set through jumper: single cooling/two tube cooling/four tube cooling/heating modes, etc
Both second-line electric valves and small air valves can be controlled
LCD display system working status: clear at a glance
LED indicates the operating status and power on status of the two-way valve
Set the temperature to increase/decrease by 1 ℃: higher accuracy
Real time clock display, timed on/off on weekdays
Room temperature correction function
Installation method:< Connect the driver board (power board) of this controller to the fan coil unit, electric valve (solenoid valve or air valve), and power cord according to the requirements in the diagram
Connect the LCD motherboard to the power driver board via the wiring harness
Remove the back cover of the LCD motherboard and insert the power driver board into the pre embedded cassette
Secure the back cover with screws
Insert the panel into the back cover and complete the installation
Operation method:
1. Press the power button to select the system's on or off state
2 M： Mode key, select the control mode of the system, whether it is cooling or heating. Refrigeration is to lower the ambient temperature, otherwise it is heating
3. Wind speed key, select the size of the output wind with the key. The wind speed can be divided into three categories: low, medium, and high. Different blades, in descending order, are high, medium, and low
4. Set the temperature. You can set the temperature level. If you need heating, the temperature you set should be higher than the indoor temperature, and the mode is heating. Otherwise, if it is lower than the indoor temperature, the mode is cooling